Set The Output Phase Configuration (Multi-Phase Model Only); Power On - NF DP Series Instruction Manual

3. Basic Operation

3.2.2 Set the Output Phase Configuration (Multi-phase model Only)

 Operation procedure
Switch the phase configuration setting switch in the power off state depending on the output phase
configuration.
CAUTION
 Ensure that the power is off when you switch the phase configuration setting switch. If the
power is on when you switch the phase configuration setting switch, the output phase
configuration will not be switched. Also, this operation does not affect the behaviors of the
product. If you move the phase configuration setting switch by mistake in the power on
state, be sure to move it back to the original position. Otherwise the product starts up in
unexpected output phase configuration when at power-on next time.

3.2.3 Power On

Press "On" side of the power switch. If you configured a polyphase system, all cabinets need to be
turned on within 20 seconds while the order does not matter.
46
1φ2W
1φ3W
POWER
スイッチをスライドさせて設定する。
Set the switch by sliding it.
3φ4W
OFF ON
PROGRAMMABLE AC POWER SOURCE