Working with the printer
Correcting the left offset
Setting corrections on the left edge must be made separately for each tray
that is installed.
1
Press the [ON LINE] key.
The display shows OFF-LINE. The printer has been switched Off Line.
2
Press the [MENU] key until SETTINGS MENU is displayed.
3
Press the [SCROLL] key until the tray to be corrected and LEFT
OFFSET are displayed.
4
Press the [SELECT] key until the desired correction value for the top
offset is displayed.
❍
Increasing the value (+) reduces the size of the left offset.
❍
Reducing the value (-) increases the size of the left offset.
5
Press the [COMFIRM KEY] to save your Offset correction.
An asterisk (*) is displayed on the right next to the selection.
6
Print out another test page to check your corrections to the offsets, see
page 6-14.
Rev. 3.1.1/16.07.99
PagePro 25
6
6-17