Table of Contents
Advertisement
2
5
Set the paper in place between the
paper guides. The stack of paper
must not exceed the maximum
filling height (see the orange mark
on the tray).
6
Close the tray.
7
Set the selection switch to the
Paper size you just loaded.
?
What if your Paper size is not
listed on the selection switch?
You are using a custom Paper
size.
➜
Set the selection switch to "User
Set" and see the tip below.
Are you using special paper?
If you load special paper, envelopes or custom formats into tray 1, you
must make a special setting for this in the printer menu, see page 5-16.
2-16
Unpacking, setting up and pre-settings
PagePro 25
Rev. 3.1.1/16.07.99
Advertisement
Table of Contents
