Table of Contents
Advertisement
Installing optional accessories
4
Insert the module into the "SIMM 1
connection slot at a 45± angle."
Push it down carefully until it snaps
into place.
5
Replace the metal plate and fasten
it in place with the seven screws.
6
Replace the upper cover of the
printer.
7
Print out the printer's configuration page, see page 2-21.
The PostScript 3 ROM module is listed under the installed options with
the status "installed".
The installation has been successfully completed.
?
What if the PostScipt 3-ROM module is not listed?
➜
Make sure the module is installed correctly.
Would you like to remove the PostScript 3-ROM module?
To remove a module, press the metal tabs on both sides of the
connection slot outward. This will release the module and allow you to
remove it.
Rev. 3.1.1/16.07.99
SIMM3 SIMM4 SIMM5
PagePro 25
SIMM1
1
2
7
7-31
Advertisement
Table of Contents
