Instructions For Running-In; Checks Prior To Starting Work - Linde E12 Operating Instructions Manual

4
Operation

Checks prior to starting work

Instructions for running-in

The forklift truck can be run at high speeds
straight away. However, in the first 50 operat-
ing hours avoid subjecting either the operating
hydraulics or the traction drive to high contin-
uous loads . In the initial operating period and
after every wheel change tighten the wheel
fastenings before start-up, and then every 10
operating hours until they have settled into
position, i.e. retightening is no longer possible
. And then every 100 operating hours. The
Checks prior to starting work
Check charge state of battery
Check braking system and parking brake
Check electrical system (lights, windscreen
wipers, horn, heating)
24
wheel fastenings should be tightened cross-
wise with a torque of
front: 210 Nm
rear:
210 Nm
NOTE
Observe the tightening instructions on the tag
attached to the steering column
Check condition and function of driver's
seat and seat belt
Check tyres
Operating Instructions – 386 807 1001 EN – 03/2006