Change Pressure Filter - Linde E12 Operating Instructions Manual

5
Servicing
Inspection and maintenance every 3000 operating hours or every 2 years

Change pressure filter

ENVIRONMENT NOTE
Take note of information about working ma-
terials. Hydraulic oil will escape so place a
collection vessel underneath beforehand.
Fully lower fork carriage.
Press emergency cut-off knob and remove
key switch.
Remove rubber mat from floor plate.
Remove floor plate.
Clean housing of pressure filter, outside
and on upper cover.
Unscrew filter cover (1) from pressure filter
using a socket or ring wrench.
Slowly pull out filter insert (2) from filter
housing.
Collect oil drips in a vessel.
ENVIRONMENT NOTE
Dispose of old filter insert and oil in an environ-
mentally friendly manner.
Fit new filter insert (2) in pressure filter.
Screw filter cover (1) back onto pressure
filter.
Tightening torque: hand-tighten (10
and then loosen a 1/4 turn.
Check pressure filter for leakage.
Vent hydraulic system.
122
+5
Nm)
Operating Instructions – 386 807 1001 EN – 03/2006
1
2
e3861376