Place Rubber Mat Back On Floor Plate - Linde E12 Operating Instructions Manual

Move the floor plate (5) up out of the way by
unscrewing the 2 fastening screws (4) on
the side of the driver's seat and attach to the
adjusting knob (8) of the steering column
with the loop (7).
NOTE
For better access to the valve block it is rec-
ommended removing the floor plate entirely.
When doing so, make sure beforehand that
the connector plug is detached from the drive
control pedal system.
Slowly turn the emergency lowering screw (1)
two or so turns anti-clockwise with a socket
wrench size SW 8 until the fork carriage is fully
lowered.
After lowering turn the emergency lower-
ing screw (1) back in clockwise (tightening
torque 10 Nm) or the fork carriage lift func-
tion will not be available via the joystick.
Retighten sealing collar nut (2): tightening
torque 9.5 Nm.
NOTE
Create lock seal between new sealing collar
nut and control valve block .
Refit floor plate.

Place rubber mat back on floor plate.

Operating Instructions – 386 807 1001 EN – 03/2006
5
Servicing
Troubleshooting
139