Suction Filter - Linde E12 Operating Instructions Manual

Inspection and maintenance every 3000 operating hours or every 2 years

Suction filter

ENVIRONMENT NOTE
Take note of information about working mate-
rials.
Fully lower fork carriage.
Press emergency cut-off knob and remove
key switch from switch latch.
Remove rubber mat from floor plate.
Remove floor plate.
Remove filter cover (1) by turning anti-clock-
wise.
Slowly pull out filter cartridge (2) so oil can
run back into hydraulic tank.
Remove filter cartridge entirely.
Unscrew breather.
Remove cover (1) from old suction filter
insert (2).
Fit cover (1) onto new filter insert.
ENVIRONMENT NOTE
Dispose of old filter insert and oil in an environ-
mentally friendly manner.
Clean seal of filter cover and wet with oil.
Carefully insert new filter cartridge in hy-
draulic tank.
Turn filter cover clockwise to arrest.
Observe arrow marking on cover and hy-
draulic tank. When closed properly, arrows
should match up.
Screw breather back on.
Check for leakage of filter cover (1) during
trial run.
Operating Instructions – 386 807 1001 EN – 03/2006
Servicing
1
1
e3861377
5
2
123