Linde E12 Operating Instructions Manual page 71

Press any key to start input device.
Green LED (2) flashes.
Enter personal PIN number (factory setting
= ) and state code.
0 0 0 0 0
I.e. the following PIN number if vehicle is OK :
appears on the display.
0 0 0 0 0 0
NOTE
If an incorrect input is made, the PIN number
can be corrected by pressing key
Confirm input using key
Green LED (2) lights up continuously.
NOTE
If the red LED (1) lights up, an incorrect PIN
number has been input. Press
peat input . If more than three incorrect inputs
are made (factory setting), the red LED (1)
lights up and the green LED (2) flashes. The
input of a valid PIN is blocked for 10 minutes.
The blocking time can be interrupted by enter-
ing a special PIN number. Please contact your
fleet manager.
Turn the rotary button (in place of key
switch) clockwise as far as it will go and
start the vehicle.
NOTE
If the vehicle does not start properly the first
time, the start procedure can be repeated until
the rotary button is returned to the zero posi-
tion and the PIN number is no longer stored
after expiry of the delay time.
NOTE
If the green (2) and red (1) LED both light
up continuously, the data must be read out.
Please inform your fleet manager at once.
Switch off vehicle and log off:
Turn the rotary button (5) anticlockwise as
far as it will go.
The engine is turned off.
Operating Instructions – 386 807 1001 EN – 03/2006
(4) .
*
(3).
#
(4) and re-
*
Operation
Special equipment
1 2
1 2 3
4 5 6
7 8 9
0 #
*
4 3
4
e3861325
61