Linde E12 Operating Instructions Manual page 47

Sit down on the driver's seat (only then is
the seat switch under the driver's seat acti-
vated).
Affix the seat belt.
Pull the emergency cut-off knob (3).
Insert the switch key (2) in the key switch
and turn clockwise as far as it will go.
Symbol (11) flashes, and the operating hours
meter (13) is in service.
The battery discharge indicator (10) and all
control lights on the indicator unit (7) light up
and are extinguished after approx. 4 sec ,
apart from symbol light (12).
Slightly raise fork arms and tilt lift mast back.
Release the hand parking brake handle (1)
by pressing the release button and turn
anticlockwise through 90 degrees.
Control light (12) is extinguished.
Forwards motion
Move direction of travel lever (4) forwards.
Carefully press accelerator pedal (5).
Control light (8) lights up.
The driving speed of the forklift truck increases
the further the pedal is pressed down.
NOTE
Pressing down the accelerator pedal hard is
to no advantage as the maximum acceleration
rate is controlled automatically.
Operating Instructions – 386 807 1001 EN – 03/2006
Operation
Standard equipment
2
1 3
5
4
4
e3861369
37