Wheel Gear Oil Change (With Wheels Detached) - Linde E12 Operating Instructions Manual

5
Servicing
Inspection and maintenance every 3000 operating hours or every 2 years
Wheel gear oil change (with wheels
detached)
ENVIRONMENT NOTE
Take note of information about working mate-
rials.
Warm up wheel gear.
Stop the forklift truck so that the checking
screw (1) is at the "5 o'clock" position .
Raise the forklift truck with the jack on the
right / left and secure.
Remove drive wheel.
Place a collection vessel under the drain
plug (3).
Unscrew the drain plug (3), filling screw (4)
and checking screw (1) and allow all the
transmission oil to drain off .
Clean the area around the checking screw
(1) , drain plug (3) and filling screw (4).
Clean the magnetic plug of the drain
plug (3) .
Screw the drain plug (3) securely back in.
Tightening torque 20 Nm
Add approx. 250 cm
the filling screw hole until oil escapes from
the screwhole of the checking screw (1).
Screw the checking screw (1) and filling
screw (4) securely back in.
Tightening torque filling screw (4) 70 Nm
Tightening torque checking screw (1) 20 Nm
Repeat on 2nd wheel.
Reattach wheels and lower forklift truck
again.
130
3
oil per wheel gear to
Operating Instructions – 386 807 1001 EN – 03/2006
4
1
3
e3861305