Inspection And Maintenance Every 3000 Operating Hours Or Every 2 Years; Operating And Steering Hydraulics (Hydraulic System) - Linde E12 Operating Instructions Manual

5
Servicing

Inspection and maintenance every 3000 operating hours or every 2 years

Inspection and maintenance every 3000 operating hours or ev-
ery 2 years
Operating and steering hydraulics
(hydraulic system)
Check oil level
ENVIRONMENT NOTE
Take note of information about working mate-
rials.
CAUTION
Observe oil level, oil volume, specifications.
Check the hydraulic oil level only with the lift mast
positioned vertically and the fork carriage lowered.
Observe the recommendations for working materi-
als.
Fully lower the fork carriage.
Apply the parking brake.
Switch off the key switch.
Remove the rubber mat from the floor plate.
Via opening (see arrow) in floor plate un-
screw breather (3) with oil dipstick.
Wipe oil dipstick with a clean cloth.
Refit breather with oil dipstick securely and
remove again.
The oil level should be between the markings
(1 or 2) on the dipstick depending on the type
and height of the lift mast.
Oil level marking "1" applies to the following lift
mast versions:
• Standard lift mast with a lift height up to
5650 mm.
• Duplex lift mast with a lift height up to 4140
mm.
• Triplex lift mast with a lift height up to 4770
mm.
Oil level marking "2" applies to:
118 Operating Instructions – 386 807 1001 EN – 03/2006