Safety Regulations - Linde E12 Operating Instructions Manual

2
Safety

Safety regulations

Safety regulations
Safety regulations
This "rules enclosed with this operating
manual refer to the correct use of industrial
trucks." They must be brought to the attention
of the persons responsible, in particular to
those persons concerned with operating and
maintaining the trucks, before working with or
on the trucks.
The operating company must ensure that the
driver understands all the safety information.
Please comply with the regulations and rules,
e. g.
• Operation of industrial trucks,
• Rules for driveways and the area of opera-
tion,
• Right, duties and rules of behaviour for the
driver,
• Special operating areas,
• Information regarding setting in motion,
driving and braking,
• Information for maintenance and repair,
• Periodic checks,
• UVV inspections,
• Disposal of oils, greases and batteries,
• Other hazards.
As the operating company or responsible
person, ensure that all regulations and safety
rules that are applicable to your industrial
trucks are complied with.
When training a fork-lift truck driver who has
already been trained to BGV D 27, the
• special features of the Linde fork lift truck
(dual-pedal control, central joystick, stop
pedal),
• and any special attachments,
• special features of operation and working
area,
must be practised sufficiently by training,
driving, switching and steering, so that they
are fully mastered.
8
Only then should training on fork lift access to
the racking commence.
Safety information
DANGER
Safety devices (e.g. the seat switch) are there for
your safety.
Safety devices - of whatever kind - must never be
disconnected.
DANGER
It is forbidden to connect any safety-critical func-
tions such as a ball clamp or swivel of a fluid con-
tainer to any third additional hydraulic system that
may be fitted.
So as to prevent inadvertent opening of the clamp or
swivel, the additional function should be connected
to the first additional hydraulic system.
DANGER
Any additional drilled holes or welding to the driver's
protective roof will compromise its strength.
It is therefore strictly forbidden to drill holes in the
driver's protective roof or to weld to it.
CAUTION
Welding operations on other parts of the vehicle
can cause damage to the electronics .
Therefore before performing any welding, always
disconnect the battery and all connections to the
electronic control units.
WARNING
Depending on the duration of
operation and use, components
carrying exhaust gases and exhaust
air can become hot.
Therefore wear protective clothing.
Operating Instructions – 386 807 1001 EN – 03/2006