Crane Lifting - Linde E12 Operating Instructions Manual

4
Operation
Loading / Transport

Crane lifting

Crane lifting
DANGER
When using a crane to lift the truck, it must be spe-
cially ensured that no-one is in the work area of the
crane! Observe loading weight according to factory
nameplate.
Do not move under overhead loads! Only use round
slings and a loading crane with a sufficient load
capacity. For loading weight, incl. battery, see type
sheet .
Turn the attachment bolt (5) through 90°
and lift.
Insert round sling (3) (load capacity min.
3000 kg) in coupling sleeve .
Force down attachment bolt against the
spring pressure, turn through 90° and allow
to snap into place in catch.
Insert round sling (2) (load capacity min.
3000 kg) around traverse on outer mast of
lift mast.
Use edge protectors as a safeguard from
sharp edges on traverse.
Insert all ends into crane hook (1).
Make sure that safety lock (4) is closed .
NOTE
During lifting, the lifting gear should not touch
the driver's protective roof, the cover on the
counterweight and any additional equipment
attached.
Crane lifting with crane eyes
CAUTION
With crane lifting pulling at an angle the crane eyes
may break off.
Crane lifting with crane eyes should only be carried
out with the appropriate lifting gear (3), where the
chains (2, 6) lead up vertically from the crane eyes
(1, 7). Make sure that safety lock (5) is closed.
72
4
3
2
1
Operating Instructions – 386 807 1001 EN – 03/2006
5
6
1
e3861379