If this procedure is NOT followed, it may result in a damaged OpenBus driver circuit . The risk of a damaged circuit increases if the accessory has a high

start current (in rush current) .

NOTE - Use of internal mains signal in software or on OpenBus

Please be aware when using the internal mains signal on control boxes with SMPS that the mains signal may take up to 6 seconds before disappearing

after mains has been removed .

Battery operation:

BATTERY LEVELS

Battery High: > 20 V

Battery Medium: 18-20 V

Battery Low: < 18 V

• If the battery voltage is at 'Medium level', a battery alarm beeps as long as a key is activated . (Medium level means that battery charging is necessary

to maintain the best possible lifetime) .

• If the battery voltage is at 'Low level', the battery alarm function shuts down all movement immediately . The OpenBus is still active for approx . 15

seconds . If trying to operate the system anyway, the battery could get deep drained or the actuator system could get damaged . When at low battery

level (which is critical), there is a risk that the processor will incorrectly monitor the end of stroke . Crashing the actuator could be a result .

• The CO53 with battery back-up only starts battery charging when it is connected to the mains .

)

The LINAK

190 Watt power supply, a small and compact design and the ability to handle multiple hand controls

or other OpenBus accessories for applications with a need for more advanced features .

Features and options

• Control concept: Relays (EAS protection)

Usage

• Operation temperature: +5 °C to +40 °C

• Storage temperature: -10 °C to +50 °C