• In order to maintain the cable flexibility, it is important to place a coiled cable in such a way that its own weight does not strain the coil during the

washing process .

• When changing hand controls for OpenBus™ systems, the power must be switched off .

• Clean the hand control regularly to ensure good hygiene standards .

• It is recommended to check the hand control and cable for damage and holes caused by violent handling before washing the application or at least

once a year .

• Do not submerge the hand control into water .

• Keep the hand control in upright position with the cable downward when washing .

• Does not comply with the 10/15 rule (IEC 60601-2-52:2009 Annex BB . 3 .3 .3)

• Be aware of the current consumption which is 28 mA . With all LEDs lit it will be 65 mA .

LED current consumption:

Red LED

1 .2 mA

Yellow LED

1 .7 mA

Green LED

3 .9 mA

White LED

1 .3 mA

Warnings

• Do not sit or lie on the hand control . It can cause unintended movement of the bed .

• If the hand control shows signs of damage, is dropped or otherwise damaged, the LEDs and backlight might be unfit to use and might show incorrect

information .

• Inform the customer that after loss of mains power, the lock state is reset to the default setting . Be aware of a special setup for a magnet lock of low

power system in case of power down on mains . Also be aware that the lock is reset when running on battery or when powered down .

• Inform the customer that using the magnet key cannot wake up a low-power system or a system running on battery . The system will wake up when

a key is activated .

• Inform the customer that a powerful magnetic field may change the lock state .

• Always use O-ring on connectors and cable locks .

)

+5 °C to + 40 °C

-10 °C to + 50 °C

20% to 80% - non-condensing

800 to 1060 hPa

700 to 1060 hPa

IEC60601-1