Generel Assembly Instructions - Linak Inline LA20 User Manual

Generel assembly instructions

Please read the following safety information carefully . Ensure that all staff who are to connect, mount, or use the actuator system are in possession of
the necessary information and that they have access to these assembly instructions .
Persons who do not have the necessary experience or knowledge of the product/products should not use the product/products . Moreover, persons with
reduced physical or mental abilities must not use the product/products, unless they are under surveillance or they have been thoroughly instructed in
the use of the equipment by a person who is responsible for the safety of these persons . Moreover, children must be under surveillance to ensure that
they do not play with the product .
Warnings
Failure to comply with these instructions may result in accidents involving serious personal injury .
• If there is visible damage on the product it should not be installed .
• If the actuator system makes unusual noise or smells, switch off the mains voltage immediately .
• The products must only be used in an environment that corresponds to their IP protection class .
• The cleaners and disinfectants must not be highly alkaline or acidic (pH value 6-8) .
• Irrespectively of the load, the duty cycle stated on the product label must NOT be exceeded .
• The control box must only be connected to the voltage stated on the label .
• Systems not specified for pull must only be used in push applications .
• Fastening screws and bolts must be tightened correctly .
• Specifications on the product label must under no circumstances be exceeded .
• NOT TO BE OPENED BY UNAUTHORISED PERSONS .
• Only use the actuator within specified working limits .
• Be aware that during the design of medical devices, the risk of personal injury (for instance squeezing of fingers or arms) must be minimised .
• If irregularities are observed, the actuator must be replaced .
Failing to follow these instructions may result in actuator system damage:
• Prior to assembly/disassembly, ensure that the following points are observed:
- The actuator system is not in operation .
- The mains current supply is switched off and the plug has been pulled out .
- Actuators are free from loads that could be released during this work .
• Prior to operating the actuator system, check the following:
- Actuator system components are correctly mounted as indicated in the relevant user instructions .
- The equipment can be operated in its entire intended range of movement .
- Ensure that the load-supporting bolts can withstand the wear .
- Ensure that the load-supporting bolts are secured safely .
• During operation:
- Listen for unusual sounds and watch out for uneven movement . Stop the actuator system immediately if anything unusual is observed .
- Do not sideload the actuator .
- Do not step on or kick the actuator .
• When the equipment is not in use:
- Switch off the mains supply or pull out the plug in order to prevent unintentional operation .
• Note:
- When changing the cables on a LINAK actuator system, it is important that this is done carefully in order to protect the plugs and pins .
Please ensure that the plug is in the right location and properly inserted before the cable lid is mounted .
Page 11 of 11