All control boxes with a microprocessor must be initialized before start-up . A description of the initialization procedure can be obtained from your LINAK

dealer . If an actuator is replaced, the microprocessor always has to be initialized before use (actuators with reed/hall) . If re-programmed, please ensure

that the correct software is used .

External battery charger

If anything other than a LINAK

Charging current: < 300 mA .

Recommendations

• Please note mains cable must be ordered separately

HOT PLUGGING

Removing or adding any OpenBus™ cables are not allowed when the CB is powered by mains supply! If necessary anyway follow the below procedure:

1 . Remove mains and wait 5 sec .

2 . Mount or dismount the required cables

If this procedure is NOT followed it may result in a damaged OpenBus™ driver circuit . The risk of a damaged circuit increases if the accessory has

a high start current (in rush current) .

• Please note mains cable must be ordered separately .

Battery running:

• If battery capacity is under 50% a "bip" sound is given for 2 seconds, when a hand control key is pressed .

• If the system is activated and the mains plug is pulled out, the system will stop . In the opposite case, if the system is running using battery power

and the mains plug is then plugged in, the system will continue running .

• The charging indicator can blink if the system operates with a high load causing the voltage to drop and because of this the batteries will start to

charge .

• The CB20 with battery back-up only commences battery charging when it is connected to the mains .

• A running battery must be charged for at least 12 hours before use .

• For recommendations on charging cycles and first use of the BA20 battery pack, please refer to chapter 5 .

12. CBR1 (MEDLINE

CARELINE

)

CB20 is a platform which offers a unique safety concept, logging off service data and it is possible to

connect a variety of accessories to the control box .

The CB20 consists of 3 modules :

CP20 = Control Power

For recommendations on maintenance and storage of the BA20 battery packs,