Information On Start-Up, Deinstallation And Operation - Linak Inline LA20 User Manual

2. Information on start-up, deinstallation and operation

Before installation, deinstallation, or troubleshooting:
• Stop the actuator/lifting column .
• Switch off the power supply or pull out the mains plug and pull out the plug to the actuator/lifting column .
• Relieve the actuator/lifting column of any loads, which may be released during the work .
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual .
• The individual parts (actuator/lifting column/hand controls etc .) must be connected before the control box is connected to the mains .
• Make sure that the mains voltage to be connected to the product or the system is the one stated on the label .
• The equipment can be moved freely over the whole working area of the actuator/lifting column .
• Check correct function after mounting .
• The actuator/lifting column must not be loaded in excess of the values indicated in the specifications on the product label .
• The duty cycle noted on the product label must always be observed . Otherwise there is a risk of product damage . Exceeding the duty cycle will result
in a dramatic reduction of the system lifetime .
Unless specified otherwise on the product label, the duty cycle is max . 10%, max . 2 minutes in use followed by 18 minutes not in use .
• The actuator/lifting column system may only be used in an environment corresponding to the IP rating of the system . LINAK products are marked
with the actual IP rating on the label .
• If any individual parts are suspected to be damaged, do not install the parts, but return them for inspection/service .
During operation:
• Check for unusual sounds and irregular movement . Stop the actuator/lifting column immediately if anything unusual is observed .
• If the control box makes unusual noises or smells, switch off the mains voltage immediately and the external battery, if any .
• Take care that the cables are not damaged .
• Unplug the mains cable on mobile equipment before it is moved .
Page 29 of 295