Ba18 - Linak Inline LA20 User Manual

2. BA18 (MEDLINE CARELINE
®
Usage
• Compatibility:
• Ambient temperature:
• Charging:
• Charging time:
• Recharging during storage: Battery recharging no later than 6 months after production date stated on the label
• Operating temperature:
• Storage temperature:
• Relative humidity:
• Atmospheric pressure:
• Meters above sea level:
• Approvals:
To ensure free passage of gasses when the battery is mounted on a flat surface the back side of the battery has been supplied with venting channels
see below figure .
Venting channels and membrane on BA18:
Check with regular intervals that the venting channels are unblocked .
Warnings
• The battery case is only to be opened by authorised staff as incorrect handling may compromise the IP protection .
• Take care to always keep the venting channels free . Mounting plates must be rigid to prevent blocking of the venting channels .
• Do not use third party chargers .
Recommendations
• Allow the battery to settle to room temperature before use .
• The batteries must be stored in an applicable storage room to avoid direct sunlight .
)
®
The BA18 is a cost-effective lead acid battery without integrated charger that can be used in combination with
CO53 and with the long-established control box range, of which many are now legacy products .
CO53, CB6P2
Legacy products : CB6,CB7, CB9, CB12, CB14, CB18, CB6S
NOTE: (only specific versions may be compatible)
+5°to +40°C
Via LINAK control box with integrated charging circuit
Approx . 6 hours depending on built-in control box charger
+5 °C to +40 °C
-10 °C to +50 °C
20% to 80% non-condensing
700 to 1060 hPa (3000 m)
Max . 3000 meters
IEC60601-1, ANSI/AAMI ES60601-1, CAN/CSA-22 .2 No . 60601-1
Page 209 of 295