Connecting The System - Linak Inline LA20 User Manual

Connecting the system

Do not connect the mains cable until all actuators and hand controls have been connected to the control box .
Start by connecting the hand control to the control box . The connection in the control box is marked with "HB" .
Connect the different actuators to the different channels on the control box . Each channel is marked with a number (e .g . "1", "2", "3"...... .) .
Check that all plugs are well connected and firmly pushed into the connector . Due to the fact that LINAK control boxes are designed for a high IP
®
degree, a firm force can be required .
Connect the mains cable.
The actuators can now be operated by pressing a button on the hand control button .
LINAK
LINAK actuator or lifting column
LINAK hand control
control box
Any non-detachable power supply cord with mains plug is considered to be the disconnecting device .
Charging is only allowed in dry environment, and the appliance inlet must be thoroughly dried before connecting to mains .
a) Actuators with plugs may only be connected to LINAK control boxes
b) Actuators without plugs are connected as shown in Figures 6.1 - 6.12.
Page 26 of 295