Replacing The Led Lamp - Epson C Series Maintenance Manual

C4 Maintenance 14. Replacing the LED Lamp

14. Replacing the LED Lamp

■ Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors with
the power ON is extremely hazardous and may result in serious bodily injury as
the Manipulator may move abnormally, and also may result in electric shock
and/or malfunction of the robot system.
■ To shut off power to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
WARNING
DO NOT connect it directly to a factory power source.
■ Before performing any replacement procedure, turn OFF the Controller and
related equipment, and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of the robot system.
Maintenance Parts
Tools
158
Name
LED lamp
Cross-point screwdriver
LED lamp
Quantity
For the part code, refer to the 17. C4
1
Maintenance Part List.
1 For covers
C Series Maintenance Manual Rev.2
Note