Joint #6 Bevel Gear - Epson C Series Maintenance Manual

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

2.3.8 Joint #6 Bevel Gear

C Series Maintenance Manual Rev.2

Remove the Arm #5 grease inlet cover.

Hexagon socket head cap bolts: 4-M3×6

Remove the O-ring located in the base groove.

Apply grease to the mating surface of the bevel

gear inside the Arm #5.

Grease: SK-2

Grease amount: 2g

Apply a thin coat of grease (SK-2) to the O-ring.

Fit the O-ring into the base groove.

Do not allow the O-ring to come out of the

If the O-ring is swollen, damaged, or

deteriorated, replace it with a new one.

Install the Arm #5 grease inlet cover.

Hexagon socket head cap bolts: 4-M3×6

Tightening torque: 2.0 ± 0.1 N·m

C8 Maintenance 2. General Maintenance