Epson C Series Maintenance Manual page 101

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

6. Remove the Arm #1 plate.

Hexagon socket head cap bolt: 6-M4×12

7. Turn the Manipulator to the opposite side and remove the

Hexagon socket set screws: 2-M5×10 (with a brass bushing)

There is a brass bushing in one of the set screws.

Be careful not to lose it.

8. Remove the screws securing the reduction gear unit.

Hexagon socket head cap bolts: 16-M4×30

By removing the screws, the Arm #2, #3, #4, #5, and #6 (end

effector) can be separated.

Have at least two workers so that one can support the

Manipulator while the other worker is removing the bolts.

Wipe grease on the parts while removing them.

9. Remove the wave generator from the reduction gear unit.

If the wave generator unit does not come off easily, set the

pulley 2 as shown in the photo to the shaft and pull out the

Remove the wave washer on the Arm #2 hole. The wave

washer will be used again. Be careful not to lose it.

Wipe grease on the parts while removing them.

C Series Maintenance Manual Rev.2

C4 Maintenance 6. Joint #2

Arm #1 plate