Epson C Series Maintenance Manual page 88

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

C4 Maintenance 5. Joint #1

4. Install the flexspline to the shaft end face.

Insert the spacer between the screws and the part.

Hexagon socket head cap bolt: 6-M6×15

Tightening torque: 17.6 N·m (180 kgf·cm)

Install the flexspline to match the air

flex spline with these of the spacer.

5. Apply grease all over the tooth flank of the circular spline.

Grease: SK-1A

Grease amount: enough to fill the grooves

6. Install the circular spline.

Hexagon socket head cap bolt: 16-M4×20

Tightening torque: 4.9 N·m (50 kgf·cm)

7. Apply grease to the inside of the flexspline.

Grease: SK-1A

Grease volume: 40 g

escapement holes of the

C Series Maintenance Manual Rev.2