Led Lamp - Epson LS20-B Series Manual

Maintenance 12. LED Lamp

12. LED Lamp

■ Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors with
the power ON is extremely hazardous and may result in serious bodily injury as
the Manipulator may move abnormally, and also may result in electric shock
and/or malfunction of the robot system.
■ To shut off power to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
WARNING
DO NOT connect it directly to a factory power source.
■ Before performing any replacement procedure, turn OFF the Controller and
related equipment, and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of the robot system.
Maintenance
LED Lamp
parts
Cross-point screwdriver
Tools
Nippers
Material Wire tie
(1) Remove the Arm Top Cover.
LED Lamp
Removal
(2) Disconnect the X1 and X2 terminals from the
(3) Turn the lens counterclockwise to remove.
(4) Remove the LED and ring from the User Plate.
LED Lamp (1) Connect the X1 and X2 terminals to the LED.
Installation
(2) Put the User Plate between the ring and lens
(3) Mount the lens.
(4) Install the Arm Top Cover.
156
Name
For details, refer to Maintenance: 3.1 Arm Top Cover.
LED.
Then, turn the lens holder counterclockwise to
remove.
Each terminal must be connected to the same
terminal number on the LED.
holder, and then secure the LED to the cover.
For details, refer to Maintenance: 3.1 Arm Top Cover.
Qty. Note
1
2077258
1 For wire removal
1
1
Lens
Lens Holder
Ring
LED
X1 Terminal
X2 Terminal (opposite side)
LS20-B Rev.4