Table of Contents
Advertisement
C12 Maintenance 6. Joint #2
6.4 Joint #2 - Replacing the Electromagnetic Brake
Electromagnetic brake (Joints #1, #2)
Maintenance
Parts
Belt tensile jig*
Hexagonal
wrench
Cross-point screwdriver
Tools
Torque wrench
Feeler gauge (0.5 mm)
Belt tension meter
Cloth (cushioning)
* The belt tensile jig is an assembly jig. Use the jig when adjusting belt tension.
The brake is mounted on each joint to prevent the arm from lowering due to its own weight while the
Controller power is OFF or the motor is OFF status. The brake does not work during replacement.
Be careful when performing maintenance work.
When removing the Joint #2 motor, tilt the Arm #2 and press it against the Arm #1.
Reference: C12 Maintenance: 6.1 Joint #2 - Replacing the Motor, Removal step (2)
When pressing the arm, put a piece of cloth or a similar material between the arms to avoid contacting each
other. This protects the arm surfaces from scratching and paint peeling off.
Removal: Joint #2 Electromagnetic brake
1. Remove the Joint #2 electromagnetic brake.
For details, refer to C12 Maintenance: 6.1 Joint #2 – Replacing the Motor, Removal steps (1) through (11).
Installation: Joint #2 Electromagnetic brake
1. Mount the Joint #2 electromagnetic brake to the Joint #2 motor unit.
For details, refer to C12 Maintenance: 6.1 Joint #2 – Replacing the Motor, Installation steps (2) through
(11).
556
Name
width across flats: 2.5 mm
width across flats: 3 mm
width across flats: 4 mm
width across flats: 5 mm
Qty.
1
2172926
1
1674582
1
For M5 hexagon socket set screw
1
For M6 hexagon socket set screw
1
For M5 hexagon socket head cap bolt
1
For M6 hexagon socket head cap bolt
1
For cross recessed head screws
1
For tightening torque control
2
For adjusting the pulley position
1
Refer: Unitta U-505
1
For pressing arms
C Series Maintenance Manual Rev.2
Note
Advertisement
Table of Contents
