Epson C Series Maintenance Manual page 105

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

9. Install the reduction gear unit.

Hexagon socket head cap bolt: 12-M4×30

Tightening torque: 4.9 N·m (50 kgf·cm)

Installation face of the Arm #2 reduction gear unit has

clearance holes.

Install the reduction gear unit to match the screws and the

clearance holes.

10. Grease the inner side of the flexspline.

Grease: SK-1A

Grease amount: 30 g

11. Set the wave washer to the position where the Arm #2 bearing

will be set.

12. Insert the wave generator to the reduction gear unit and fix it.

C Series Maintenance Manual Rev.2

C4 Maintenance 6. Joint #2