REP 10.6.1 STM PWB
Parts List on PL 10.6
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
Static electricity may damage electrical parts.
Always wear a wrist band during servicing. If a wrist band is not available, touch some metallic
parts before servicing to discharge the static electricity.
1.
[Two Tray Module]
Remove the Cap. (Figure 1)
a.
Release the hook to remove the Cap.
Figure 1 j0mg41001
2.
[Two Tray Module]
Disconnect the connector. (Figure 2)
a.
Remove the cable band.
b.
Disconnect the connector.
Version 1.0
WC 5022/5024
WARNING
CAUTION
3.
Remove the Docking Bracket (x2). (Figure 3)
a.
Remove the Docking Screw (x2).
b.
Remove the Docking Bracket (x2).
4.
Remove the Rear Cover of the One Tray Module. (Figure 4)
a.
Remove the screw (x2).
b.
Remove the Rear Cover.
06/2014
4-37
Figure 2 j0mg41002
Figure 3 j0lj41003
Repairs and Asdjustments