Xerox WorkCentre 5022 Service Manual page 138

073-105 Regi Sensor On Jam (Tray 3)
BSD-ON: CH8.4
The Regi Sensor did not turn ON within the specified time after the Feed Out Sensor 2 is On
during paper feed from Tray 3.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path.
• Usage of out of spec paper.
• The Drive Gear for wear and damage.
• The Tray 2 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• Regi Sensor: Input Check [071-105] (PL 15.1)
• Feed Out Sensor 2: Input Check [072-106] (PL 10.5)
• STM Takeaway Motor: Output Check [072-007] (PL 10.6)
• STM Takeaway Roll Clutch: Output Check [072-005] (PL 10.6)
If no problems are found, replace the following parts in sequence:
• STM PWB (PL 10.6)
• ESS/MCU PWB (PL 18.3)
Status Indicator RAPs
073-105 Regi Sensor On Jam (Tray 3)
073-210 Tray 3 Lift Up Fail
BSD-ON: CH7.7
One of the following errors was detected.
• The Tray 3 Lifter error was detected.
• The Tray 3 Paper Size detector component malfunction was detected.
NOTE: If this is already detected, it will be displayed on the UI Panel when a Job is being per-
formed.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• The Tray 3 paper supply mechanism for damage and foreign substances.
• Usage of out of spec paper.
• Tray 3 Nudger Level Sensor: Input Check [072-108] (PL 11.3)
• Tray 3 Feed/Lift Up Motor: Output Check [072-010] (Lift Up) (PL 11.3)
• Tray 3 Paper Size Switch: Analog Monitor [072-052]/Input Check [072-110] (PL 11.1)
If no problems are found, replace the following parts in sequence:
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
06/2014
2-116
Version 1.0
WC 5022/5024