Xerox WorkCentre 5022 Service Manual page 537

6.5.2.8 DATA All Delete
Purpose
Erases the customer's data in the machine for security reasons when a PWB was replaced, the
machine was removed, etc.
6.5.2.8.1 DATA All Delete (Controller NVM)
Purpose
To initialize the following data that are stored in the ESS/MCU PWB.
• Job History
Procedure
1. Enter the CE Diag Mode and input 999-970 in the Chain-Link.
2. Pressing <Start> displays the initialization confirmation on the UI.
• To initialize, press <Start> to start the initialization.
• To cancel initialization, press <Clear (C)> to return to the [Diagnostics Mode Base]
screen.
3. Perform the initialization. When the initialization has completed, [Done] will be displayed.
4. Pressing <Clear (C)> returns you to the [Diagnostics Mode Base] screen.
6.5.2.8.2 DATA All Delete (Fax NVM)
Purpose
To initialize the following data that are stored in the Fax Kit.
• Local Terminal Information
• Telephone Book
• Jobs Stored for Transmission Information
• Various Reports
• Sending Data
• Receiving Data
• System Parameter (Default Value for each Market)
Procedure
1. Enter the CE Diag Mode and input 825-730 in the Chain-Link.
2. Pressing <Start> displays the initialization confirmation on the UI.
• To initialize, press <Start> to start the initialization.
• To cancel initialization, press <Clear (C)> to return to the [Diagnostics Mode Base]
screen.
3. Perform the initialization. When the initialization has completed, [Done] will be displayed.
4. Pressing <Clear (C)> returns you to the [Diagnostics Mode Base] screen.
Version 1.0
WC 5022/5024
6.5.2.9 Test Pattern Print
Purpose
Performs copy quality check by printing the Test Pattern in the machine.
Procedure
1. Enter the CE Diag Mode.
2. Input the Chain-Link No. of the Test Pattern to print.
NOTE: The 24 Gradation Density Pattern (998-905 and 998-906) can only be output on
A3.
Chain-Link Type
998-901 Blank Image
998-902 Solid black
998-903 Stripe
998-904 Grid Pattern
998-905 24 Gradation Density Pattern
(A3) (ATCN24KED)
998-906 24 Gradation Density Pattern
(A3) (ATCN24KDI)
3. The default values for the setting screen are - Quantity: 1, Tray 1, and 1 to 1 Sided.
4. Select the [Quantity], [Paper Supply] and [1 to 2 Sided].
NOTE: The Quantity can be specified up to 2 digits, with the maximum of 99.
5. Selecting Tray 5 (MSI) displays the [Paper Size] and [Paper Type] settings screen. The
default values for this settings screen are as follows:
• The values that were set most recently will be displayed.
6. When the Test Pattern output has completed, [Done] will be displayed.
7. Pressing <Clear (C)> returns you to the [Diagnostics Mode Base] screen.
06/2014
6-109
Table 1
Overview
Outputs a blank printout.
Outputs a solid black printout.
Outputs a black and white stripes printout.
Outputs a grid pattern printout.
Outputs a 24 gradation density pattern
(ATCN24KED) printout.
Outputs a 24 gradation density pattern
(ATCN24KDI) printout.
6.5.2.8 DATA All Delete
General