Xerox WorkCentre 5022 Service Manual page 140

074-104 Feed Out Sensor 2 On Jam (Tray 4)
BSD-ON: CH8.2
The Feed Out Sensor 2 did not turn ON within the specified time after the Feed Out Sensor 3 is
On during paper feed from Tray 4.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path.
• Usage of out of spec paper.
• The Drive Gear for wear and damage.
• The Tray 2 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• The Tray 3 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• Feed Out Sensor 2: Input Check [072-106] (PL 10.5)
• Feed Out Sensor 3: Input Check [072-109] (PL 11.5)
• STM Takeaway Motor: Output Check [072-007] (PL 10.6)
• STM Takeaway Roll Clutch: Output Check [072-005] (PL 10.6)
• 2TM Takeaway Motor: Output Check [072-008] (PL 11.6)
• 2TM Takeaway Roll Clutch: Output Check [072-006] (PL 11.6)
If no problems are found, replace the following parts in sequence:
• STM PWB (PL 10.6)
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
Status Indicator RAPs
074-104 Feed Out Sensor 2 On Jam (Tray 4)
074-105 Regi. Sensor On Jam (Tray 4)
BSD-ON: CH8.4
The Regi Sensor did not turn ON within the specified time after the Feed Out Sensor 2 is On
during paper feed from Tray 4.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path.
• Usage of out of spec paper.
• The Drive Gear for wear and damage.
• The Tray 2 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• Regi Sensor: Input Check [071-105] (PL 15.1)
• Feed Out Sensor 2: Input Check [072-106] (PL 10.5)
• STM Takeaway Motor: Output Check [072-007] (PL 10.6)
• STM Takeaway Roll Clutch: Output Check [072-005] (PL 10.6)
If no problems are found, replace the following parts in sequence:
• STM PWB (PL 10.6)
• ESS/MCU PWB (PL 18.3)
06/2014
2-118
Version 1.0
WC 5022/5024