Xerox WorkCentre 5022 Service Manual page 238

Figure 8 j0mg40109
10. Disconnect the connector of the LCD Display. (Figure 9)
a. Open the block of the Connector Housing in the direction of the arrow and discon-
nect the Flat Cable.
Repairs and Asdjustments
Replacement
1. To install, carry out the removal steps in reverse order.
2. When connecting the UI Cable, insert it into the Connector Housing until the Line Mark of
the UI Cable is at the position indicated in the figure. (Figure 10)
3. [One Touch Panel]: When installing the Control Panel, pull out the wire harness of the
One Touch Panel through the cutout of IIT Front Cover. (Figure 11)
06/2014
4-14
Figure 9 j0mg40110
Figure 10 j0mg40106
Version 1.0
WC 5022/5024