Xerox WorkCentre 5022 Service Manual page 44

Hide thumbs Also See for WorkCentre 5022:
Table of Contents

Advertisement

005-500 DADF Download Flash Write Error
BSD-ON: CH1.3
Failed to write into the Flash ROM during DAFD Download.
Cause/Action
1.
Turn the power OFF and ON.
If the device starts up normally
Check the FW Version of the DADF. If the FW Version is not the expected version,
turn OFF the power, start up the device in Download Mode, and then try to download
again. If the problem persists, replace the DADF PWB. (PL 56.2)
If the device does not start up normally
Turn OFF the power and start up the device in Download Mode. If the device can
start up in Download Mode, try to download the FW again. If the problem persists,
replace the DADF PWB. (PL 56.2)
If it cannot start up in Download Mode, replace the DADF PWB. (PL 56.2)
Status Indicator RAPs
005-500 DADF Download Flash Write Error
005-907/908/913 DADF Pre Regi Sensor/DADF Regi
Sensor/DADF Invert Sensor Static Jam
BSD-ON: CH5.5, CH5.4
Paper was detected by the applicable sensor at Power ON, Feeder Cover Interlock Close, or
DADF Open Sensor Close.
Cause/Action
1.
Check the applicable sensor for remaining paper, the Actuator for return failure, contami-
nation on sensor, and etc.
2.
Check the applicable sensor for operation failure.
DADF Pre Regi Sensor (Input Check[005-206]) (PL 56.14)
DADF Regi Sensor (Input Check[005-110]) (PL 56.14)
DADF Invert Sensor (Input Check[005-211]) (PL 56.10)
3.
If no problem is found, replace the DADF PWB. (PL 56.2)
06/2014
2-22
Version 1.0
WC 5022/5024

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workcentre 5024

Table of Contents