Xerox WorkCentre 5022 Service Manual page 61

016-776 Marker Code Detection Fail
BSD-ON:-
During Copy Job or Print Job, when expanding only up to the size that was specified at the
expansion, the End Code cannot be found in the compressed data.
NOTE: Before the occurrence of this fail, there are cases where [045-310 Image Ready Error]
would occur first.
NOTE: During Continuous Print, this error will not occur until the paper that immediately pre-
cedes the paper where the applicable image is supposed to be printed on has been output suc-
cessfully.
Cause/Action
1. Turn the power OFF and ON.
2. If the problem reoccurs, determine whether it is caused by the Copy document or the Print
data and contact the Support Department for assistance.
Version 1.0
WC 5022/5024
016-781 SMTP Server Refusal
BSD-ON:-
The SMTP Server is refusing to send e-mails for some reasons.
Cause/Action
1. Press [Stop] on the UI Panel.
2. Set the permission at the SMTP side.
NOTE: When performing the operation again, the same Fault will occur if the user had pro-
ceeded without changing the settings.
06/2014
2-39
Status Indicator RAPs
016-776 Marker Code Detection Fail