Xerox WorkCentre 5022 Service Manual page 71

024-950 Tray 1 No Paper
BSD-ON: CH7.5
Any of the following was detected:
• The paper in the Tray 1 has ran out. (When the ATS function of Tray 1 is disabled)
• Although the paper in the Tray 1 was detected to have ran out, paper is not supplied from
another Tray. (When the ATS function of Tray 1 is enabled)
Cause/Action
1. Load paper into the Tray 1. (If this had occurred during ATS of Tray 1 or Tray 2, load
paper with the same settings as for the applicable Tray into other than MSI.)
2. If the problem persists, check the following:
• The paper supply mechanism of the applicable Tray for damage and foreign sub-
stances.
• The No Paper Sensor of the Tray 1 (Input Check [072-100]) for operation failure. (PL
9.1)
• The No Paper Sensor of the Tray 1 for contamination, improper installation, and
Actuator operation failure.
3. If no problem is found, replace the following parts:
• ESS/MCU PWB (PL 18.3)
Version 1.0
WC 5022/5024
024-951 Tray 2 No Paper
BSD-ON: CH7.6
Any of the following was detected:
• The paper in the Tray 2 has ran out. (When the ATS function of Tray 2 is disabled)
• Although the paper in the Tray 2 was detected to have ran out, paper is not supplied from
another Tray. (When the ATS function of Tray 2 is enabled)
Cause/Action
1. Load paper into the Tray 2. (If this had occurred during ATS of Tray 1 or Tray 2, load
paper with the same settings as for the applicable Tray into other than MSI.)
2. If the problem persists, check the following:
• The paper supply mechanism of the applicable Tray for damage and foreign sub-
stances.
• The No Paper Sensor of the Tray 2 (Input Check [072-101]) for operation failure. (PL
10.3)
• The No Paper Sensor of the Tray 2 for contamination, improper installation, and
Actuator operation failure.
3. If no problem is found, replace the following parts:
• ESS/MCU PWB (PL 18.3)
• STM PWB (Tray 2) (PL 10.6)
06/2014
2-49
Status Indicator RAPs
024-950 Tray 1 No Paper