Xerox WorkCentre 5022 Service Manual page 691

9.1.9 Network Print Kit
• Enables printing via a network.
Unable to scan via s network.
Product Code
• : ENG
Installation Procedures
1. Before Installation
• This Kit can be installed on CPS Local Models.
2. Check the bundled items. (Figure 1)
No Name
1 Bracket
2 Net I/F PWB
3 Instruction
4 Screw
• There is no illustration for Item 3,4
Figure 1 j0mg91024
3. Turn OFF the power switch and make sure that the screen display turns OFF.
When turning OFF the power switch, check that the "Data" lamp is OFF and that there is
no Job in progress.
4. Unplug the power plug.
Version 1.0
WC 5022/5024
Table 1
Qty
1
1
1
2
CAUTION
When maintaining the machine, turn OFF the power switch and unplug the power
plug.
5. Remove the Blind Cover at the Right Cover. (Figure 2)
a. Remove the Blind Cover.
6. Remove the STM Connector Cover. (Figure 3)
a. Remove the screw (x2).
b. Remove the STM Connector Cover.
7. [Machines with One Tray Module]: Disconnect the connector. (Figure 4)
a. Release the wire harness from the clamp.
b. Remove the cable band.
c. Disconnect the connector.
06/2014
9-23
WARNING
Figure 2 j0lj91122
Figure 3 j0mg41902
Installation/Removal
9.1.9 Network Print Kit