Xerox WorkCentre 5022 Service Manual page 137

073-102 Feed Out Sensor 3 On Jam (Tray 3)
BSD-ON: CH8.3
The Feed Out Sensor 3 did not turn ON within the specified time after the Paper had been fed
from Tray 3.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path.
• Usage of out of spec paper.
• The Drive Gear for wear and damage.
• The Tray 3 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and transpor-
tation failure due to deterioration.
• The Tray 3 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• Feed Out Sensor 3: Input Check [072-109] (PL 11.5)
• Tray 3 Feed/Lift Up Motor: Output Check [072-003] (Feed) (PL 11.3)
• 2TM Takeaway Motor: Output Check [072-008] (PL 11.6)
• 2TM Takeaway Roll Clutch: Output Check [072-006] (PL 11.6)
If no problems are found, replace the following parts in sequence:
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
Version 1.0
WC 5022/5024
073-104 Feed Out Sensor 2 On Jam (Tray 3)
BSD-ON: CH8.2
The Feed Out Sensor 2 did not turn ON within the specified time after the Feed Out Sensor 3 is
On during paper feed from Tray 3.
Initial Actions
Refer to the BSD and check the related connectors of the target electrical parts for partial con-
nections.
Cause/Action
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path.
• Usage of out of spec paper.
• The Drive Gear for wear and damage.
• The Tray 2 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• The Tray 3 Takeaway Roll and Pinch Roll for contamination, wear, and transportation fail-
ure due to deterioration.
• Feed Out Sensor 2: Input Check [072-106] (PL 10.5)
• Feed Out Sensor 3: Input Check [072-109] (PL 11.5)
• STM Takeaway Motor: Output Check [072-007] (PL 10.6)
• STM Takeaway Roll Clutch: Output Check [072-005] (PL 10.6)
• 2TM Takeaway Motor: Output Check [072-008] (PL 11.6)
• 2TM Takeaway Roll Clutch: Output Check [072-006] (PL 11.6)
If no problems are found, replace the following parts in sequence:
• STM PWB (PL 10.6)
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
06/2014
073-102 Feed Out Sensor 3 On Jam (Tray 3)
2-115
Status Indicator RAPs