Xerox WorkCentre 5022 Service Manual page 676

Figure 3 j0lj91106
9. Reinstall Tray 1.
10. Secure the Docking Bracket (x2) by using the Docking Screw (x2). (Figure 4)
a. Install the Docking Bracket (x2).
b. Secure them by using the Docking Screw (x2).
Figure 4 j0lj91107
11. Connect the connector of the One Tray Module.
a. Remove the screw (x2).
b. Remove the STM Connector Cover.
c. Connect the connector.
d. Install the cable band.
e. Paste the clamp and secure the wire harness by using the clamp. (Figure 5)
Installation/Removal
9.1.5 One Tray Module
12. Reinstall the STM Connector Cover that was removed in Step 11.
13. Load paper into Tray 2.
14. Paste the Size Label that correspond to the paper that is loaded in Tray 2. (Figure 6)
a. Paste the Size Label.
b. Paste the Size Label that correspond to the paper that is loaded in Tray 1.
15. Reconnect all the cables that are supposed to be connected to the right of the IOT.
06/2014
9-8
Figure 5 j0mg91008
Figure 6 j0lj91124
Version 1.0
WC 5022/5024