Xerox WorkCentre 5022 Service Manual page 133

072-102 Feed Out Sensor 2 On Jam
BSD-ON: CH8.2, CH7.6
During paper feed from Tray 2, the Feed Out Sensor 2 did not turn ON within the specified time
after the Tray 2 Feed Motor On.
Cause/Action
Check the following:
• The Feed Out Sensor 2 (Input Check [072-106] for operation failure. (PL 10.5)
• The STM Take Away Motor (Output Check [072-007] for operation failure. (PL 10.6)
• The STM Take Away Roll Clutch (Output Check [072-005] for operation failure. (PL 10.6)
• The Tray 2 Feed/Lift Up Motor (Output Check [072-002] (Feed)) for operation failure. (PL
10.3)
• The T/A Roll 2, Feed Roll, Nudger Roll, and Pinch Roll for transportation failure due to
contamination, wear, and deterioration.
• The LH Cover for improper latching.
• The Drive Gear for wear and damage.
• A paper transportation failure due to foreign substances on the paper path.
• Usage of out of spec paper.
If no problem is found, replace the STM PWB. (PL 10.6)
Version 1.0
WC 5022/5024
072-105 Regi Sensor On Jam (Tray 2)
BSD-ON: CH8.4, CH8.2
During paper feed from Tray 2, the Regi Sensor did not turn ON within the specified time after
the Feed Out Sensor 2 On.
Cause/Action
Check the following:
• The Regi Sensor (Input Check [071-105]) for operation failure. (PL 15.1)
• The STM Take Away Motor (Output Check [072-007] for operation failure. (PL 10.6)
• The STM Take Away Roll Clutch (Output Check [072-005] for operation failure. (PL 10.6)
• The T/A Roll 2, Feed Roll, and Pinch Roll for transportation failure due to contamination,
wear, and deterioration.
• The Drive Gear for wear and damage.
• A paper transportation failure due to foreign substances on the paper path.
• Usage of out of spec paper.
If no problem is found, replace the following parts in sequence:
• ESS/MCU PWB (PL 18.3)
• STM PWB (PL 10.6)
06/2014
2-111
Status Indicator RAPs
072-102 Feed Out Sensor 2 On Jam