B&R Panel PC 2100 User Manual page 68

Technical data
PP100/200/300/400
PP500
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices are not 100%
mounting compatible with Power Panel 100/200/300/400 devices in Vertical1 format. Automation Panel 1000, Au-
tomation Panel 900, Panel PC 700 and Power Panel 500 devices require a cutout that is 5 mm higher (bottom edge).
The larger cutout can be used for all devices under certain conditions:
• When mounting, make sure that the PP100/200/300/400 devices are placed and mounted as close to the
center of the cutout as possible. Failure to do so can prevent the retaining clips from holding firmly, which
means that a solid seal is no longer guaranteed by the gasket (IP65).
68
10 323 x 358
303 x 336
303 x 341
Outer contour of device
Cutout for PP100/200/300/400 device
Cutout for AP900/AP1000/PPC700/PP500 device
Figure 37: Mounting compatibility - 10.4" device - Vertical1
10
8.5
AP900/PPC700
AP1000
13.5 PP100/200/300/400
8.5 AP900, AP1000, PPC700, PP500
Panel PC 2100 user's manual V1.17