Lan - B&R Panel PC 2100 User Manual

BIOS setting Explanation
Center mode Displays the image in the middle of panels with-
out a scaler chip.
1) LFP = Local flat panel.
2) This setting is only possible if IGD - Boot type is set to CRT, EFP or LFP.
3) This setting is only possible if IGD - Boot type is set to LFP.
4) This setting is only possible if IGD - Boot type is set to Auto or EFP.

4.1.6.4 LAN

Main Advanced
PXE ROM
WakeOnLAN from S5
Network stack
BIOS setting Explanation
PXE ROM Option for configuring PXE boot features.
WakeOnLAN from S5 Option for switching on the system via the on-
board Ethernet controller (ETH1) from mode S5.
Network stack Configures the network stack
Panel PC 2100 user's manual V1.17
Table 241: Advanced - Graphics (IGD) configuration - IGD configuration
Phoenix SecureCore Technology setup
LAN configuration
[ Disabled ]
[Disabled]
Figure 152: Advanced - LAN
Table 242: Advanced - LAN
Configuration options Effect
Disabled Disables this function.
Auto Enables this function for all connected pan-
els/monitors.
CRT Enables this function for CRT monitors.
EFP Enables this function for panels.
Enable/Disable PCE option
ROM execution for onboard
LAN
Configuration options Effect
Disabled
Disables this function.
Onboard ETH1 only Enables this function for ETH1.
Onboard ETH2 only Enables this function for ETH2.
Both onboard only Enables this function for ETH1 and ETH2.
Add-on only Enables this function for an optional add-on
card.
Any Enables this function for all devices, ETH1 and
ETH2.
Disabled Disables this function. The Ethernet controller
cannot switch on the system.
Enabled Enables this function. The Ethernet controller
can switch on the system.
Enter Opens this submenu
256
Software
Item specific help
"Network stack" on page
255