Installing A Panel Pc With An Ap9X3 Panel - B&R Panel PC 2100 User Manual

Commissioning
• Loss of seal
Caution!
• The gasket must be inspected before initial installation, subsequent installation as well
as at regular intervals appropriate to the requirements of the operating environment.
• Replace the entire device if visible scratches, cracks, collected dirt or excessive wear
is detected during inspection.
• Do not unnecessarily stretch the gasket.
• Avoid contact between the gasket and the corners and edges of the frame.
• It is important to ensure that the gasket is completely inserted into the installation notch.
• The housing components must be secured using the specified tightening torque.
Failure to follow these instructions can result in damage to property.

3.1.2 Installing a Panel PC with an AP9x3 panel

The Panel PC 2100 with AP9x3 panel is installed in the cutout using retaining clips. The number of retaining clips
depends on the panel.
The thickness of the wall or control cabinet plate must be at least 1 mm and is not permitted to exceed 6 mm.
A 2.5 mm hex screwdriver is needed to tighten and remove the screw on the retaining clips. The maximum tightening
torque of the retaining clips is 1 Nm.
Devices must be installed on a flat, clean and burr-free surface; tightening screws on an uneven area can result
in damage to the display or the ingress of dust and water.
Procedure
1. Check whether the included mounting screws are screwed into the retaining clips. If not, then the mounting
screws must be screwed into the retaining clips with a 2.5 mm hex key screwdriver. The mounting screws
are permitted to be screwed in far enough that they no longer protrude above the retaining clip.
2. Insert the device into the front of the prepared, burr-free and flat installation cutout. For the dimensions of the
cutout, see Fig. X "AP9x3 panels - Installation diagrams" on page
212
Mounting screws
Figure 112: Preparing the retaining clips
Retaining clip
.
Panel PC 2100 user's manual V1.17