B&R Panel PC 2100 User Manual page 27

AP1000 panels with retaining clips - Installation diagrams
Figure 6: Panel PC 2100 with AP1000 panels with retaining clips (sample figure) - Installation diagram
All dimensions are specified in mm.
The cutout tolerances are +0 mm / -0.5 mm.
Display type Model number
5.7" single-touch 5AP1120.0573-000
5.7" with keys 5AP1151.0573-000
7.0" single-touch 5AP1120.0702-000
7.0" multi-touch 5AP1130.0702-000
10.1" single-touch 5AP1120.101E-000
10.1" multi-touch 5AP1130.101E-000
10.4" single-touch 5AP1120.1043-000
10.4" single-touch with keys 5AP1180.1043-000
12.1" single-touch 5AP1120.121E-000
12.1" multi-touch 5AP1130.121E-000
15.6" single-touch 5AP1120.156B-000
15.6" multi-touch 5AP1130.156C-000
18.5" multi-touch 5AP1130.185C-000
Dimension "Z" describes the thickness of the wall or control cabinet panel.
A 2.5 mm hex screwdriver is needed to tighten and remove the screw on the retaining clips. The maximum tightening
torque of the retaining clips is 1 Nm.
Information:
Additional spacing of at least 30 mm is required along the entire cutout in order to perform installation
using retaining clips.
Panel PC 2100 user's manual V1.17
X
X
199
199
199
199
268
268
303
303
313
313
403
403
464
Table 13: AP1000 panels with retaining clips - Installation diagrams
Y Z min. Z max. Number of retaining clips
143 1 8 4
232 1 8 6
143 1 8 4
143 1 8 4
180 1 6 8
180 1 6 8
243 1 10 8
243 1 10 8
210.5 1 6 10
210.5 1 6 10
247.5 1 6 10
247.5 1 6 10
284 1 6 10
Technical data
Z
27