B&R Panel PC 2100 User Manual page 195

Model number
POWERLINK
Quantity
Transfer
Type
Design
Transfer rate
Cable length
CAN
Quantity
Design
Transfer rate
Terminating resistor
Type
X2X
Type
Quantity
Design
Electrical characteristics
Power consumption
Operating conditions
Pollution degree per EN 61131-2
Environmental conditions
Temperature
Operation
Storage
Transport
Relative humidity
Operation
Storage
Transport
Mechanical characteristics
Weight
1) Yes, although applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2) For more information, see Automation Help (Communication - POWERLINK - General information - Hardware - IF / LS).
2.3.5.7.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as IF1.
Wiring
Cable length
Status LED
Green
Link LED
Yellow Link (POWERLINK net-
work connection available)
1) The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2) This interface is referred to as IF1 in Automation Studio / Automation Runtime.
Panel PC 2100 user's manual V1.17
Table 188: 5ACCIF01.FPSC-001 - Technical data
POWERLINK - IF1
S/STP (Cat 5e)
Max. 100 m (min. Cat 5e)
On Off
See Status/Error LED.
On Off
Activity (blinks to indi-
cate active data transfer)
Table 189: 5ACCIF01.FPSC-001 - POWERLINK interface
5ACCIF01.FPSC-001
1
100BASE-TX
Type 4
2)
Shielded RJ45
100 Mbit/s
Max. 100 m between two stations (segment length)
1
10-pin, male, electrically isolated
Max. 1 Mbit/s
Can be enabled or disabled using a slide switch
X2X Link master
1
10-pin, male, electrically isolated
2 W
Pollution degree 2
-20 to 55°C
-20 to 60°C
-20 to 60°C
5 to 90%, non-condensing
5 to 95%, non-condensing
5 to 95%, non-condensing
25 g
1)2)
1
LED "Link"
Technical data
RJ45, female
LED "Status"
195