B&R Panel PC 2100 User Manual page 172

Technical data
System stop error codes
A system stop error can occur due to incorrect configuration or defective hardware.
The error code is indicated by the red "Error" LED and four switch-on phases. Each switch-on phase has a duration
of either 150 ms or 600 ms. The error code output is repeated cyclically every 2 seconds.
Error description
RAM error:
The interface is defective and must be replaced.
Hardware error:
The interface or a system component is defective and must be replaced.
Legend: •
−
Pause
2.3.5.2.4 Updating firmware
The firmware is a component of Automation Studio. The module is updated to this version automatically.
To update the firmware included in Automation Studio, the hardware must be upgraded (see "Project manage-
ment" / "The workspace" / "Upgrades" in Automation Help).
172
Table 145: System stop error codes
...150 ms
...600 ms
2-second pause
Error code indicated by red "Status" LED
• • • - Pause •
- • • - Pause -
Panel PC 2100 user's manual V1.17
• • - Pause
• • - Pause