B&R Panel PC 2100 User Manual page 67

2.2.6.2.3 10.4" devices
The cutout tolerance for PP100/200, PP300/400, PP500, AP900, PPC700 and PPC800 systems is ±0.5 mm.
The cutout tolerance for the AP1000 is +0 mm / -0.5 mm.
PP100/200/300/400 PP500
PP100/200/300/400 PP500
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700, Power Panel 500 devices and Power Panel
100/200/300/400 devices are 100% mounting compatible in Horizontal1 format.
PP100/200/300/400
PP500
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices are not 100%
mounting compatible with Power Panel 100/200/300/400 devices in Horizontal2 format. Automation Panel 1000,
Automation Panel 900, Panel PC 700 and Power Panel 500 devices require a cutout that is 4.5 mm higher (bottom
edge).
The larger cutout can be used for all devices under certain conditions:
• When mounting, make sure that the PP100/200/300/400 devices are placed and mounted as close to the
center of the cutout as possible. Failure to do so can prevent the retaining clips from holding firmly, which
means that a solid seal is no longer guaranteed by the gasket (IP65).
Panel PC 2100 user's manual V1.17
10
Outer contour of device
Cutout for device
Figure 35: Mounting compatibility - 10.4" device - Horizontal1
10
Outer contour of device
Cutout for PP100/200/300/400 device
Cutout for AP900/PPC700 device
Cutout for PP500/AP1000 device
Figure 36: Mounting compatibility - 10.4" device - Horizontal2
323 x 260
303 x 243
423 x 288
402 x 266.5
402 x 271
403 x 271
Technical data
10
8.5
AP900/PPC700
AP900
8.5
10
8.5
AP900/PPC700
AP1000
13 PP100/200/300/400
8.5 AP900, PPC700, PP500, AP1000
AP1000
AP1000
67