B&R Panel PC 2100 User Manual page 213

3. Install the retaining clips on the device. This is done by inserting the clips into the openings on the sides of
the device (indicated by the orange circles). The number of retaining clips may vary depending on the panel.
For the exact number, see
4. Fasten the retaining clips to the wall or control cabinet by alternately tightening the screws with a 2.5 hex key
screwdriver. The tightening torque should be max. 1 Nm to provide an optimal seal.
control cabinet plate
Panel PC 2100 user's manual V1.17
Fig. X "AP9x3 panels - Installation diagrams" on page
Figure 113: Inserting the retaining clips (sample figure)
1 - 6 mm
Wall or
Figure 114: Fastening the retaining clips (sample figure)
Commissioning
.
213