Rear Bearing Carrier Installation - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

REAR BEARING CARRIER

INSTALLATION

1. Install drive shaft through the backside of the bearing

2. Install the four fasteners

bearing carrier to the trailing arm. Install the one

that attaches the upper radius rod to the

bearing carrier. Torque bolts to specification.

Use new nuts upon installation of the rear bearing

Bearing Carrier to Trailing Arm Bolts:

44 ft-lbs (60 Nm)

Outer Radius Rod Fastener:

52 ft-lbs (70 Nm) + 90°

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

that attach the rear

3. Clean drive shaft splines and hub assembly splines

thoroughly with contact cleaner and a wire brush.

Remove all/any Loctite® residue.

Removal of all Loctite® material is a labor intensive

process and may take up to 10 minutes or more to

complete. It is critical that these surfaces are clean and

no residual Loctite® material or corrosion is present.

4. Apply Loctite® Primer 7649 to the hub assembly

splines. Allow 90 seconds for the primer to dry.

5. Apply Loctite® 680 to the hub-side splines of the

drive shaft. Apply Loctite® 680 around the entire

circumference of the end of the hub-side splines, and

then apply Loctite® 680 in a spiral pattern as shown.

Use caution to avoid getting Loctite® on the drive shaft

threads or castle nut.

6. Install rear wheel hub assembly

and hand tighten the castle nut. Install washers with

domed side out.

, cone washer

Chapters

Table of Contents