Installing An Sfp; Removing An Sfp; Connecting An Lc Fiber Optic Cable - HP Aruba 7010 Series Installation Manual

3. The 7010 controller is now turned Off.

Installing an SFP

Use standard ESD precautions when installing or removing an SFP.
To install an SFP module into the 7010:
1. Slide the SFP module, top side facing upward, into a 1000Base-X port until a connection is made
and an audible click is heard (see
Figure 12 Installing an SFP

Removing an SFP

To remove an SFP module:
1. Open and release the latch on the SFP module.
2. Pull and remove the module from the port.

Connecting an LC Fiber Optic Cable

To connect an LC fiber optic cable into an SFP-SX or SFP-LX module:
1. Clean the fiber optic cable connector before inserting it into the SFP module.
2. Insert the fiber optic cable into the SFP module. Ensure that the latch on the cable faces the top of
the SFP module (see
3. Slide the cable into place until a connection is made and an audible click is heard.
To disconnect an LC fiber optic cable from an SFP-SX or SFP-LX module:
1. Depress the transceiver handle to release the latch on the cable and simultaneously pull the cable
out of the port.
Aruba 7010 Series Controller
Figure 13).
| Installation Guide
Figure 12).
Installation |
23